DMM - 2mm pitch metal connectors - MIL-DTL-83513G

A backshell is the rear portion of a connector, which is normally a separate section from the connector head. It is used to secure the cable to the end of the connector in order to relieve strain on solder and crimp joints. It also shields against electrical interference (EMI/RFI protection), mechanical injury or physical damage due to environmental conditions.  Nicomatic Transfer Impedance is under 200mOhm from 10Khz to 400Mhz, which allows us to offer an excellent & clean data transfer from an emitting device to a receptor.

Nicomatic connectors, especially the MIL-DTL-83513G DMM® connector range, have to be more and more compatible with high & harsh requirements. To reach this target and in a continuous spirit of improvement we have decided to upgrade our assembly process.

The end user of the radar systems requires the system to be durable, reliable and with low maintenance.  In-order to track multiple targets, the system needs to have the most accurate information transmission and its protection of signal. The expectation of radar manufactures is very high, and that is why they demand excellent quality and performance from each component that makes up the entire system.

DMM series is a rugged, compact and shock resistant connector system. It is available in an all LF or mixed-layout configuration, with high frequency and/or high power contacts with possible arrangements of between 1 and 4 rows of contacts with up to 120 contacts.

The multiplication of data in electronic systems could have disastrous results if the impact of the cross talk was not anticipated. Under an electromagnetic perturbation (EMI, RFI or EMP), the cable’s conductor acts as antennas and picks up the radiated signals. The reception of this interference surely impacts the initial signal integrity.